Just Auto Repair

Car Repair Help and Answers

How To Check Engine Drive Belts - Routing

Inspect your serpentine drive belt every 10,000 miles. Look for cracking. Small cracks are normal. Large, deep cracks are a sign that the belt should be replaced.

Learn how to check your belt with this Video.

More Auto Repair Help

Grand Am ETS and Engine light Code P0171 P0134 P0125

I have a Pontiac Grandam 2.4 Lire. The ETS light comes on by itself when engine is warm with or without check engine light coming on. The check engine codes vary from P0171, P0134, P0125. Severe black smoke from the exhaust when ETS light on very poor gas milage when on. Starts fine cold or

...
 
Audi Runs A While Then Stalls

1986 audi 5000
Engine Size : 5 cly
Question: 1986 audi 5000 cd. Runs then quits, changed fuel relay, fuel filter seems to have lots of pressure. Help.

Answer: Assuming this is a gas engine,  just guesing that your Audi has a fuel problem is the wrong thing to do. You need to start with some

...
 
How to Replace Trailblazer 4 Wheel Drive Switch

More Auto Repair Help

2006 Chevrolet Trail blazer LS.
Engine Size : 6 cylinder.
Question: trying to remove my dash so that i may get at the switch that changes from a 2 wheel to auto to 4 hi to 4 low the switch is broken and needs to be replace but no one will say how to get at this switch.

Answer:

...
 

Comments 

 
# ford escort zx2 2010-11-09 08:57
belt routing
Reply | Reply with quote | Quote
 
 
# Sandra 2010-12-08 17:05
tensioner diagram for 1993 F-150 5.0
Reply | Reply with quote | Quote
 
 
# barbieiam 2010-12-31 15:11
Help today if possible for a 1993 Dodge Caravan to replace a serpentine belt..problem: Can not figgure out how to release tension on tensioner on this model only????????
12/31/2010 asap
Reply | Reply with quote | Quote
 
 
# barbieiam 2010-12-31 15:13
can not take off tension on Serpentine belt on 1993 Dodge Caravan on tensioner help asap 12/30/10 asap please
Reply | Reply with quote | Quote
 
 
# Tech 2011-01-02 04:07
The tensioner and idler pulley have similar pulleys. The belt tensioner is below the alternator. You need to get a wrench on the center bolt and rotate the tensioner clockwise to release the tension
Reply | Reply with quote | Quote
 
 
# Lis 2011-02-07 20:47
Need diagram for serpentine belt on 2003 for escape 3.0 v6
Reply | Reply with quote | Quote
 
 
# dee 2011-04-25 15:48
need diagram for serpentine belt on chrysler pacifica 2005
Reply | Reply with quote | Quote
 

Add comment

FACT: A turn signal blinking very fast on one side is usually just a bad bulb. If bulbs are good then check for a lose or corroded socket. This would look green from water, or black if burned.