P0036 - P0056
Heated oxygen sensors (HO2S) are used for fuel control and post catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content in the exhaust stream. The HO2S must reach operating temperature to provide an accurate voltage signal. A heating element inside the HO2S minimizes the time required for the sensor to reach operating temperature.
Voltage is provided to the heater by the ignition 1 voltage circuit through a fuse. With the engine running, ground is provided to the heater by the HO2S heater low control circuit, through a low side driver within the engine control module (ECM).
The ECM commands the heater ON or OFF to maintain a specific HO2S operating temperature range. The ECM monitors the voltage on the HO2S heater low control circuit for heater fault diagnosis. If the ECM detects that the HO2S heater low control circuit voltage is not within a specified range, DTC P0036 sets for HO2S bank 1 sensor 2, or DTC P0056 sets for HO2S bank 2 sensor 2.
Related Auto Repair and Information
More Auto Repair Help
1994 Olds Cutlass supreme SL.
Question: how do i remove at home the front drivers strut safely and replace it? Don't have the funds to take it to a mechanic shop. so i have to replace at home. Answer: WARNING: Please read completely before attempting this repair.
Well, first jack up the car and ... |
|
2005 Chrysler T/C Limited
Engine Size : v6
Question: The Chrysler Town and Country van has the electric door package.The front doors work just fine.
The rear doors will not open or unlock when the button on the remote is pushed. I checked the battery, not the issue. When I wanted to open the rear doors prior I would hit ... |
|
1993 Buick Park Ave. 3.8L.
Warning lights: service engine soon, inflatable restraint.
Codes: throttle position sensor.
Question = the engine got hot in my 1993 Buick Park Ave.w/3.8L V-6 and spun the crank everything else worked great! so i bought a used engine that is low mileage and runs excellent ... |
|