Cutlass

Read about some problems and repairs for the Oldsmobile Cutlass. You may find some help to do it yourself.


1998 Oldsmobile Cutlass 3.1L.

Repairs: Temp. sensor replaced, fuel sending unit replaced, dash instrument cluster replaced, all fuses checked
Question: I have a 1998 Oldsmobile Cutlass, the fuel & temp. gauges read empty & cold, no high beam indicator light on dash. high beams do work. no power to switch to the left of steering wheel, next to dash light dimmer switch.

1995 Oldsmobile Cutlass Ciera. Engine size = 3.1. Check engine light.

My car keeps blowing EGR gaskets, the intake is clean, and we have put 8 or 9 on the car and i keeps on blowing the gaskets. The sensor is OK and the vacuum is OK. but we cant figure it out.

1993 Oldsmobile Cutlass 3.4L V6

I have no way to find out codes.
Repair work done prior = new fuel pump,filter.screen,regulator.
What is causing car to idle OK but when pressing on gas pedal the motor runs bad and will pop out of the pipes. car did not run prior to putting in new fuel pump.actually i had to change it 3 times before getting fuel pressure.

Latest Articles

Chevrolet Blazer Lost Power ...

2000 blazer 4x4 lost power to drivetrain going down the ...

Dodge Durango Timing Chain ...

My 03 Dodge Durango 4.7L engine was blowing white smoke ...

2002 Chevy Blazer Keeps ...

My 2002 blazer keeps dying on me when I am driving, and ...

1996 Lumina Dies Looses ...

1996 Chevy Lumina 3.1 L. I have good fuel pressure,spark ...

Silverado Won't Start Cold

My 1992 Silverado 6 cylinder turns over but will not run if ...

How Things Work

Car and Truck Seat Belts Operation

The front seat belt system includes the following components:

  1. The driver and the passenger seat belt retractor on all sedans is located and attached to the center pillar.
  2. The driver and the passenger seat buckle with pretensionor are attached to lower inner side of each front seat. Read more...

Common Engine Codes

Code P0420 Catalytic Converter Failure

To control emissions of hydrocarbons (HC), carbon monoxide (CO), and oxides of nitrogen (NOx), a three-way catalytic converter is used. The catalyst within the converter promotes a chemical reaction which oxidizes the HC and CO present in the exhaust gas, converting them into harmless water vapor and carbon dioxide. The catalyst also reduces NOx, converting the NOx to nitrogen.

Read more...