Delta 88

Delta 88 and 98 Regency car repair help.


91 Oldsmobile Regency 98 3.8 V6.
Just changed out a small fuel line to the relay had a hole in
Question = i ran my car to the store it ran fine then coming back it shut off like gasping for gas shut it off started it up again OK for about 5 min then same thing after starting it again i made it home can someone please help this is driving me nuts.

Read more...

1998 Oldsmobile Delta.
Engine Size : 6 cylinder 3800.
Question: My car cuts off after running for about 10 minutes. It won't start back up till the engine is cool. So replaced the fuel pump, the fuel filter and the crank position sensor. After putting in the sensor it still cranks when engine cools cuts off as soon as it gets hot. What else could it be.

Read more...

Hello, I own a 1982 Olds Delta 88 Royale Brougham. While changing from low-beams to high-beams, I lost all lights before switching back to low-beams. My Chilton's manual says this is due to a fusible link, but doesn't tell where the link is. Could you help me identify where the link is and the steps in changing it.

Read more...

I have 1998 olds Delta 88.Engine light was coming on,shows MAP sensor and erg valve.One me ch. said bad wires(big problem),one said change sensors.I notice this happened in winter,in summer is OK,if was not good have to be always bad.

The day I changed thermostat I notice two vacuum lines have split in connector,I tape the connector,no more codes,this cost may be 0.05c,No hundreds.

Read more...

1996 Oldsmobile Delta 88 3.8L V6.
Throttle position sensor,maf sensor...map sensor
Question: I have a hitch,a jack hammering type of hitch,with certain positions of the throttle...car goes great...seems if it starts to hitch it will stop when i change throttle position...could it be i got a bad sensor from the parts store?

Read more...

1988 Oldsmobile Delta 88 Royal V6.
Service engine soon light.
GM Computer codes = no
Replaced water pump and thermostat replaced.
Replaced brain, cam and crank sensors, and electronic distributor pack, ( part with the plug wires ). had the ignition module ,i think that's the name, checked and was told it was good.

Read more...

1994 Oldsmobile Eighty Eight 6 cylinder.
Question: my check engine light keeps coming on and my engine is racing and it wont slow down.

Answer: First you need to get a scan of the computer codes. This can be done for free at most of the national parts store chains. This would give an indication as to what system is having a problem.

Read more...

Latest Articles

Chevrolet Blazer Lost Power ...

2000 blazer 4x4 lost power to drivetrain going down the ...

Dodge Durango Timing Chain ...

My 03 Dodge Durango 4.7L engine was blowing white smoke ...

2002 Chevy Blazer Keeps ...

My 2002 blazer keeps dying on me when I am driving, and ...

1996 Lumina Dies Looses ...

1996 Chevy Lumina 3.1 L. I have good fuel pressure,spark ...

Silverado Won't Start Cold

My 1992 Silverado 6 cylinder turns over but will not run if ...

How Things Work

Power Steering- Electric- How Does It Work

The electric power steering (EPS) system reduces the amount of effort needed to steer the vehicle. The system uses the body control module (BCM), power steering control module (PSCM), torque sensor, discrete battery voltage supply circuit, EPS motor, serial data bus, and the instrument panel cluster (IPC) message center to perform the system functions.

Read more...

Common Engine Codes

Code P0341 Cam Position Sensor

During cranking, the ignition control (IC) module monitors the 7X crankshaft position sensor signal. Once the IC module determines spark synchronization, 3X reference signals are sent to the powertrain control module (PCM). The PCM will command all six injectors on for one priming shot of fuel in all cylinders.

Read more...