During cranking, the ignition control (IC) module monitors the 7X crankshaft position sensor signal. Once the IC module determines spark synchronization, 3X reference signals are sent to the powertrain control module (PCM). The PCM will command all six injectors on for one priming shot of fuel in all cylinders.

After the priming, the injectors are left off for the next six fuel control reference signals, two crankshaft revolutions. This allows each cylinder a chance to use the fuel from the priming shot. During this waiting period, a cam pulse will have been received by the PCM. The PCM uses the cam signal pulses to initiate sequential fuel injection. The PCM constantly monitors the number of pulses on the cam signal circuit and compares the number of cam pulses to the number of 24 X reference pulses and the number of 3 X reference pulses being received. If the PCM receives an incorrect number of pulses on the cam reference circuit, DTC P0341 will set and the PCM will initiate injector sequence without the cam signal with a one in six chance that injector sequence is correct. The engine will continue to start and run normally, although the misfire diagnostic will be affected if a misfiring condition occurs.

Related Auto Repair and Information

More Auto Repair Help


Please login to comment

Comments (3)
   ---Subscribe To Your Comment   

  • Guest - jess rodgers

    2003 venture no 24x signal

  • Guest - Madgesand1@aol.com

    Where is the camshaft located in a 2006 Dodge Grand caravan? I also need to replace the Knock Sensor. Where is that located?

  • Guest - Mechanic Paul

    In reply to: Guest - Madgesand1@aol.com

    Where is the camshaft located in a 2006 Dodge Grand caravan? I also need to replace the Knock Sensor. Where is that located?
    <br />It is located under the intake manifold in the engine valley between the cylinder heads.