Chevy S-10 and Colorado Pickup Repair

It's a Chevy s10 it just cuts off going down the Road. You can put in neutral N wait a min or two sometimes longer and it will crank back.

1997 Chevy S10 Engine Size : 2.2 134L 4 cly. Question: 1997 Chevrolet S-10 LS with 179,000 miles 4 cyl Manual 2 Wheel Drive 1997 Chevrolet S-10 97 S10 engine 2.2 134L remove cylinder head have a bad lifter and Camshaft do I replace the lifter and Camshaft in this motor with a 179000 miles or just rebuild the engine with rebuild kit

1989 Chevrolet S10 Blazer Engine Size : 4.3 Question: The problem with my car started the about 2 days ago, or at least that's when we noticed it. My husband started it and it immediately died. He started it again, gave it a little gas, and it was fine for the rest of the day. Last night it sounded like it was struggling to start, but it did start and i made it to the store.

2005 Chevy Colorado 4x4. Engine Size : 3.5 Question: I've purchased a replacement wiper motor for this truck. The blades do not set properly. They no longer lay down. They now set about 6 inches from the base. No one seems to know how to set the wiper blades properly. Please let me know how to do this.

2002 Chev S-10 4X4. 190 HP Vortec 4300 V6 SFI Eng. Question: The engine light comes on and when I read the code I get P0446. What is that code.

Answer: Code P0446 is a problem in the evaporative emissions system (EVAP) Vent Valve. The valve is either not functioning because it is faulty, there is a wiring problem to the valve

4.3 Vortec 1989 Chevy s-10. Question Here. Give as much detail as possible. : I'm stumped...no brakes, no one can help....hard pedal before starting but when starting pedal goes to floor...replace items master cylinder, power booster. Used proportion valve. Bleed and bleed ...no avail...i guess to a master shop.

2000 Chevy S10. 4.3L Vortec. Question: Hi i have no temp gauge or gas gauge transmission and millage only work when key is in on but when motor is running they go out .Dome light only work on over ride or thumb wheel not when you open door.

Problem with my = 2004 Chevy Colorado. 5 cylinder engine.Tune up, replaced sensors, replaced spark plugs multiple times, replaced plug cores.
Idles rough.  Runs fine when accelerating.Cuts off when in reverse or moving slowly forward.  No codes, check engine light does not come on.

2004 Chevy Colorado 3.5l engine. Repaired once at my expense, twice under warranty, once more after warranty expired, at my expense. Total of four failures in six years. Looking for a permanent fix to HVAC blower resistor pack burnout.  Last two times the connector was also replaced, but since it failed last time, I expect it to fail again with the advent of warm weather and constant blower use for AC.

Latest Articles

Impala Flashing Engine Light

I have a 2003/2004 impala i was driving it on the high way ...

Hyundai Tucson 2016 A/C Blows ...

2016 Hyundai Tucson. A/C worked great, parked the car for a ...

Chevrolet Blazer Lost Power ...

2000 blazer 4x4 lost power to drivetrain going down the ...

Dodge Durango Timing Chain ...

My 03 Dodge Durango 4.7L engine was blowing white smoke ...

2002 Chevy Blazer Keeps ...

My 2002 blazer keeps dying on me when I am driving, and ...

How Things Work

Air Bag (SIR) System Function and Operation

The Supplemental Inflatable Restraint (SIR) system supplements the protection offered by the driver and front passenger seat belts. The SIR system deploys an air bag from the center of the steering wheel and from the right side of the instrument panel. The knee bolsters and the steering column absorb crash energy. The driver and passenger knee bolsters are below the instrument panel.

Read more...

Common Engine Codes

Throttle Position Sensor Code P0121, P0122 and P0123

The throttle position (TP) sensor is used by the powertrain control module (PCM) to determine the throttle plate angle for various engine management systems. The TP sensor is a potentiometer type sensor with three circuits: a 5-volt reference, a low reference, and a signal. The PCM provides the TP sensor with a 5-volt reference circuit and a low reference circuit.

Read more...